The name of this manual has been changed from "Apple CD Drives" to
"AppleCD SC/SC Plus." Information about the AppleCD 150 has been moved from this manual to the AppleCD 150/300 manual.
LaserWriter Pro
LaserWriter Pro - Basics
A diagram of the solder-side view of the pickup controller board has been added. Multimeter readings can only be taken from the solder side of this board.
LaserWriter Pro - Basics
Sensor input signals and a
photo detail of the pickup controller board have been added to the wiring diagram. The relationship between the transfer block assembly and the toner cartridge contacts is now fully illustrated.
In addition, the order of pins for connector J201/J601 has been corrected.
LaserWriter Pro - Basics
In the previous release of Service Source, the multipurpose paper-end and paper-present sensors had incorrect signal notations. MPS now reads "L when paper is detected" and MPE reads "H when paper is detected."
LaserWriter Pro - Basics
A paragraph describing internal hard drives has been added.
LaserWriter Pro - Basics
The procedure “Maintaining Pickup Connectivity” has been added to “Troubleshooting Tips” in
the Basics chapter. This technique enables you to take voltage readings from the paper pickup block and allows you to watch a pickup cycle.
LaserWriter Pro - Specifications
The amount of RAM in the LaserWriter Pro 600 has been changed from 4 MB to 8 MB. This change reflects Apple's decision to release all versions of the LaserWriter Pro with PhotoGrade and 600 dpi capability.
LaserWriter Pro - Flowcharts
A Flowcharts chapter has been added to the LaserWriter Pro manual. The chapter includes topics on print quality and paper transport problems, as well as seven topics that correspond to the printer diagnostic errors. Refer to the “Print Engine Check” topic to confirm printer operation after servicing a LaserWriter Pro—or if none of the other available topics addresses your problem.
LaserWriter Pro - Take Apart Steps
The order in which I/O shield screws are replaced has been changed. The screw in the lower left corner of the I/O shield must go in first, and the screw in the lower right corner must go in second.
LaserWriter Pro - Take Apart Steps
A "Separation Pad" topic has been added to the Take Apart chapter.
LaserWriter Pro - Additional Procedures
The topic “Capacitor Discharge” has been added to Additional Procedures. This procedure
eliminates the 10-minute shut down that follows a fuser error.
LW Pro Sheet Feeder
LW Pro Sheet Feeder - Detailed Parts
Graphics for the drive block components of the sheet feeder
have been added to the Illustrated Parts chapter (Group 4).
Duo Dock
Duo Dock - Basics
This card describes the new, enhanced version of the Duo Dock,
which includes a 230 MB hard drive, FPU chip, and 512K VRAM SIMM.
Duo Dock - Specifications
Several cards in the Specifications chapter have been modified
to reflect a new, enhanced Duo Dock configuration. The enhanced
configuration includes a 230 MB hard drive and a logic board that
comes with a 68882 math coprocessor and 1 MB of video RAM (512K of soldered VRAM plus a 512K VRAM SIMM).
Duo Dock - Detailed Parts
An Illustrated Parts note has been added to this card explaining that the subassembly comes with a floppy drive cable, HDA cable, and HDA power cable. You can also order these cables separately.
PowerBook 140/145/170
PowerBook 140/145/170 - Take Apart Steps
On this card, previous releases of Service Source incorrectly identified the interconnect cable as a display cable.
PowerBook 160/180
PowerBook 160/180 - Illustrated Parts
A procedure for replacing the daughterboard heat sinks has been added to the "Daughterboard" topic of Take Apart.
Notices
Notices - Product Information
The Special Tools List has been updated.
Programs
Programs - Repairing
The Apple Direct Shipping and Handling telephone and fax numbers for Airborne Express have been updated.
Programs - Parts List
The Disk Exchange Parts List has been updated.
Programs - Parts List
The Other Media Exchange Parts List has been updated.
Programs - Parts List
The Manual Purchase Parts List has been updated.
SCSI Hard Drives
SCSI Hard Drives - Detailed Parts
New 80 MB SCSI hard drive for Macintosh IIvx and Performa 600
computers was added.
LaserWriter II
LaserWriter II - Detailed Parts
Part number 922-0339 "20T Fuser Gear, version B" has been added to
the Illustrated Parts List. Version B has a plastic throat that extends out from the side of the gear about 1/4 inch. You must replace the version of the gear like for like. A QuickTime photo in the Illustrated Parts List shows the difference between the two versions.
Personal LaserWriter
Personal LaserWriter - Specifications
A correction has been made to the amount of RAM that the Personal
LaserWriter NTR can address. The specifications now read "NTR: 3 MB expandable to 4 MB."
IIvx/IIvi/Per 600
IIvx/IIvi/Per 600 - Detailed Parts
A new 80 MB hard drive (part number 661-0774) has been added.
PowerBook 100
PowerBook 100 - Detailed Parts
The part number for Sony backup batteries is included in an Illustrated Parts List note for part number 949-0036.
PowerBook 160/180
PowerBook 160/180 - Symptom Charts
The "Video" topic in Symptom Charts has been revised. In particular, the symptom "Row or partial row of pixels never comes on or is always on" has been broken into two symptoms: "Row or partial row of pixels never comes on (white line)" and "Row or partial row of pixels is always on (black line)." Each symptom has a revised list of cures.
PowerBook 160/180 - Illustrated Parts
The heat sink kit (part number 076-0069) has been removed from the January Service Source CD. The heat sink kit will be available
from Apple in February.
PowerBook Duo 210/230
PowerBook Duo 210/230 - Illustrated Parts
IPL hard drive part numbers in Group 5 have been revised and corrected. Currently, there are
two hard drives available for the PowerBook Duo 210/230: part number 661-0796, an 80 MB drive, and part number 661-0772, a 120 MB drive.
SIMMS
SIMMS - Configuration
The LaserWriter Pro has been added to the LaserWriters Configuration menu.
SIMMS - Detailed Parts
A new 4 MB SIMM (part number 661-0808) has been added to the SIMMs manual.
SIMMS - Detailed Parts
A new 8 MB SIMM (part number 661-0809) has been added to the SIMMs manual.
Notices
Notices - Product Notices
The Apple IIGS Power Supply Repair Extension Program (0LL444) expired January 15, 1993.
Notices - Printers
Labor reimbursement information for installing the ROM in in-warranty or out-of-warranty LaserWriter IIf/IIg printers was added.
Programs
Programs - Apple Support
New operating hours were added for the Technical Support phone lines.
Programs - Financials
LaserWriter IIf/IIg ROM Upgrade reimbursement information was added.
Programs - Financials
LaserWriter IIf/IIg ROM Upgrade reimbursement information was added.
